Table of Contents
Advertisement
Available languages
Available languages
INSTRUCTION MANUAL
Problem
The equipment does not work
Abnormal compressor operation
or buzz
The compressor has been run-
ning for too long and there is no
frost on the evaporator's surface.
There is frost or ice on the cam-
era's internal walls and it has a
too low internal temperature. The
compressor always runs, it never
stops.
The internal temperature is too
high and the compressor runs, it
never stops.
Too much noise
The light is not on
J
.P. SELECTA s.a.u.
CODE 80366 REV 0
TROUBLESHOOTING
Possible cause
Plug's bad connection
Supply voltage is outside the
nominal range
The cooling system is damaged
(leaking or blocked)
The thermostat does not work
Bad heat dissipation and venti-
lation of the housing, the room
temperature is too high.
Door frequently open and for a
long time.
Unit is not level
Pipes touch the compressor.
The light has melted
Warning:
- Keep the ventilation openings unobstructed, inside the appli-
ance or in the built-in structure.
- Do not use mechanical devices or other means to accelerate
the defrosting process.
- Do not use electrical appliances inside the storage compart-
ments of the equipment.
- It is forbidden to disassemble the unit by non-professional per-
sonnel, it can be dangerous.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
NOV2018
(It can be modified without notice)
Solution
Unplug it and reconnect it to
the power supply
Disconnect the power source
immediately and reconnect it
when the voltage is normal. It
is necessary to have a voltage
stabilizer in case of poor power.
Send the unit to the technical
service for repair.
Take it to the technical service
to repair.
Improve ventilation and lower
ambient temperature.
Decrease time and number of
times of door openings.
Adjust the adjustable feet
Carefully separate the pipes
that touch each other.
Replace it
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Pag.: 14
Advertisement
Table of Contents
