Table of Contents
Advertisement
Available languages
Available languages
MANUAL DE INSTRUCCIONES CODIGO 80366
REV 0 NOV2018
(Sujetas a modificaciones sin previo aviso)
Pag.: 13
PRODUCTS STORAGE
Do not put too many products at the same time in the equipment,
you should leave some space around the products so that cold air
can flow into the chamber. Keep bottled items away from the inside
walls of the chamber so they do not freeze as they might break.
Shelves can be adjusted according to different needs.
Do not place hot products directly on the equipment until it
cools down to normal temperature, to avoid reducing the power
consumption and prolonging life of the compressor.
MAINTENANCE
Disconnect power supply before performing maintenance
on the machine.
Keep the door seal clean, remove it from the door and wash it.
Dry and seal as before. Put some talcum powder on the magnetic
surface to prolong its life.
Replacing the light: remove the upper cover, remove the bulb,
replace it with a new one and reassemble it all. Bulb power is 6W,
& voltage is AC220V/50Hz or AC110V/60Hz.
If there is a lot of ice in the evaporator after prolonged use, remove
things from inside the chamber, turn the power off, and automatica-
lly the frost will melt. Clean the water and turn the power on again.
To clean the unit, use a soft cloth and wipe it with a little soap and
water (or a neutral, non-caustic detergent). Dry it after cleaning
it to avoid oxidation.
Do not use organic liquids, reservoir water, detergent powder or
acid to clean the unit. Do not use a hard or steel brush to clean
the equipment.
If you are not going to use the equipment for an long period of
time, disconnect it from the power supply, clean it by following the
steps above, and dry the water inside the camera with a soft cloth.
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
Advertisement
Table of Contents
