Table of Contents
Advertisement
11. TROUBLESHOOTING
Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
The loading
door does not
close
Not possible to
change the pro-
gram or option.
Not possible to
select an option.
Acoustic signal
is emitted.
Possible cause
1)
The tumble dryer is not connected
to the mains supply.
The door is open.
The On/Off button was not push-
ed.
The Start/Pause button was not
touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Dryness Level option was set to
4)
iron dry .
The load was too large.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
The filter is not locked into posi-
tion.
Laundry is trapped between the
door and the seal.
After cycle start it is not possible to
change the program or option.
The option you tried to select is
not available for the selected pro-
gram.
Remedy
Connect to the mains socket.
Check fuse in fuse box (domestic
installation).
Close the door.
Push the On/Off button.
Touch the Start/Pause button.
Push the On/Off button.
Select a suitable program.
3)
Clean the filter.
Change Dryness Level option to
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
ENGLISH
19
2)
5)
3)
Advertisement
Table of Contents
