Connecting The Rear-Panel Cables - HP 70907A Installation And Verification Manual

Connecting the Rear-Panel Cables

This section contains the instructions for connecting the EMIM when it is used in an existing
HP 71210C system. For HP 71210C system con guration information, refer to the Installation
and Veri cation Manual for the system's master.
Figure 2-4 illustrates the rear-panel cable connections for the HP 71210C system with an
EMIM added. Make the following changes and additions to the HP 71210C system cabling
when an EMIM is added:
Disconnect the cable between HP 70903A 21.4 MHz IN and HP 70908A 21.4 MHz OUT.
Disconnect the RF-section end of the cable connected between HP 70900B TUNE SPAN
and HP 70908A TUNE SPAN. Connect an SMB tee (1250-1391) to HP 70908A TUNE
SPAN, then connect the cable from HP 70900B TUNE SPAN to the tee.
Connect the following ports with the cables listed:
HP 70907B LO IN to HP 70908A 1ST LO OUT. (5021-5493)
HP 70907B TUNE SPAN to the tee on HP 70908A TUNE SPAN. (5061-9017)
HP 70907B 300 MHz IN to HP 70900B 300 MHz OUT 2. (5061-9021)
HP 70907B 21.4 MHz OUT to HP 70903A 21.4 MHz IN. (5061-9021)
HP 70907B 21.4 MHz IN to HP 70908A 21.4 MHz OUT. (5061-9017)
Installation 2-5