Advertisement
Quick Links
RST-1WS Rolling Work Seat
Quick Start Guide
P/N 5900244 — Rev. A — Jan. 2020
The RST-1WS Rolling Work Seat keeps you comfortable while you do wheel or service work. Less bending over
or working on your knees means you work more efficiently and you hurt less.
The components of the RST-1WS are:
• One Seat. Padded for your comfort.
• Two Horseshoe Pieces. Metal. Hold up the seat and get you up off the ground.
• One Base. Metal. Holds the other components together.
• One Work Tray. Plastic. Holds tools and easy-to-lose parts. Sits inside the Base.
• Four Wheels. Move the Work Seat. Each Wheel has threads that connect it to the Base.
• Two Screw/Washers. Connect the long section of the Horseshoe Pieces to the Seat.
• Four Bolt/Washer/Lock Washer/Nut sets. Connect the Base and Tray to the short sections of the
Horseshoe Pieces.
Side view, except where noted. Not necessarily to scale. Some components shown spread out for clarity.
1645 Lemonwood Dr.
Santa Paula, CA, 93060 USA
(800) 253-2363
rangerproducts.com
© 2020 BendPak Inc. All rights reserved.
1 of 2
Advertisement
Summary of Contents for Ranger RST-1WS
- Page 1 P/N 5900244 — Rev. A — Jan. 2020 The RST-1WS Rolling Work Seat keeps you comfortable while you do wheel or service work. Less bending over or working on your knees means you work more efficiently and you hurt less.
- Page 2 Refer to the drawing on the previous page as you set up the Rolling Work Seat. To set up the RST-1WS Rolling Work Seat: 1. Open the box and remove the contents. 2. Put the plastic Work Tray inside the metal Base. Make sure the holes are aligned.