Clean The Water Inlet Filters - Bosch WAX32GH1GB User Manual And Installation Instructions

en Cleaning and servicing

Clean the water inlet filters.

Clean the filter in the water inlet in the
event of blockages or if the water pres-
sure is too low.
Emptying the water inlet hose
Turn off the tap.
1.
Set a programme, except for Rinse ,
2.
Spin or Drain .
Start the programme and leave it to
3.
run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
54
Clean the filter with a small brush.
2.
Connect the water inlet hose and
3.
check for leaks.
Cleaning the filter on the appliance
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Requirement: The water inlet hose is
empty.
→ "Emptying the water inlet hose",
Page 54