Related Manuals for Chapman Machinery W240
Summary of Contents for Chapman Machinery W240
- Page 1 W240 Weed Wiper Original Instructions Chapman Machinery Ltd, Hele Barton, Week St. Mary, Holsworthy, Devon EX22 6XR Tel: 01288 308149 Email: sales@chapman.co.uk...
-
Page 2: Table Of Contents
The information contained in this manual is correct at the time of going to press. However, in the course of development, changes in specification are inevitable. Should you find the information given differs from your machine, please contact Chapman Machinery Ltd direct for advice. Use only Chapman Genuine Service Parts on Chapman Machinery and Machines. -
Page 3: Hse Information
HSE Information Safe use of all-terrain vehicles (ATVs) in agriculture and forestry – AIS Sheet 33 Remember that your ability to control the ATV by your body Introduction movements will be considerably reduced when carrying a load or towing a trailer. This information sheet gives advice on the safe use of ATVs. -
Page 4: Important Safety Information
Important Safety Information Always read this manual before fitting or operating the machine – whenever any doubt exists contact your dealer or the Chapman Machinery Service Department for advice and assistance. DEFINITIONS The following definitions apply throughout this manual: WARNING - An operating procedure, technique etc., which can result in personal injury or loss of life if not observed carefully. -
Page 5: Description
Description The W240 Weed Wiper is designed for the selective application of herbicide to weeds / vegetation on pasture. The W240 Weed Wiper is a trailed attachment, with applicator roller rotated around a horizontal plane in direction counter to the direction of motion. This ensures even coverage of the waterborne herbicide to the underside of the weeds. - Page 6 * Carefully read operators manual *Caution - Entanglement Hazard. Keep hands away from moving before handling this machine. parts Observe instructions and safety rules when operating. Component Identification Page 6...
-
Page 7: Attachment
Attachment Before Attaching the Machine Before attachment, ALWAYS ensure the following: • All safety guards & decals are in good working order and correctly fitted • Lubrication points have been lubricated as per scheduled maintenance period • The tyres are free of damage and inflated to the correct pressure •... -
Page 8: Operation
Operation Ensure that the operator is suitably qualified to use a machine of this nature and that they have fully read and understood this manual - they should be aware of all safety aspects relating to the safe use of the machine. -
Page 9: Operation
Operation 1. Switch the unit on by pressing ON/OFF. The display will light-up and the roller will rotate. 2. After approx. 3 seconds the display will show the previous application rate last used between 0-100. Use the UP / DOWN arrows to adjust if required. 3. -
Page 10: Troubleshooting
Troubleshooting Problem Possible Causes Remedies Applicator motor does not Poor connection Check plug is clean and moisture operate free Shortage in wiring (may be Check wiring for damage indicated by unit losing power when run button pressed) Motor Fault Replace motor, contact distributor Pump does not operate Poor connection Check plug is clean and moisture... -
Page 11: Warranty
The Chapman warranty be transferred to a subsequent owner of the machinery (for use within the UK only) for the balance of the warranty period subject to all of the stated warranty conditions and provided that the Change of Owner form is completed and sent to Chapman Machinery within 14 days of change of owner- ship. - Page 12 Hele Barton Week St. Mary Holsworthy Devon EX22 6XR The Products Covered by this Declaration Product: W240 Weed Wiper (Off-Highway) Standards and Regulations used: Machinery Directive 2006/42/EC Place of Issue: United Kingdom Name of Representative: James Chapman Position of representative:...