Starting The Programme; Programme Follow-Up; Cancelling The Programme - Beko DFS05012W User Manual

Operating the product

Starting the programme

To start your machine after selecting the
programme and auxiliary functions, press
Start/Pause/Cancel key.
C
Your machine performs water
softening depending on the
hardness level of the mains
water. Due to water softening
process the programme
duration may change. The
programme duration can also
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the dishes.
C
Pay attention not to open the
door of the machine when it is
running. Stop the machine by
pressing Start/Pause/Cancel
key if you have to open the
door. Then, open the door of
the machine. There may be a
rush of vapour when you open
the door of your machine; be
careful. Close the door of your
machine and press Start/Pause/
Cancel key again. Programme
will resume running.
C
After the rinsing step, the
machine will wait silent in pause
mode for some time in order
to have the water remaining in
the machine and on the dishes
drained completely and to have
the water softener cleaned, and
then it will resume running in
drying mode.
28 /38 EN

Programme follow-up

You can track the current step of the
selected programme on the programme
step lights located on the control panel.
C
If the drying light is on, the
machine will perform silent
drying for 30-60 minutes. At the
end of this period, the Drying
light will go off and the End light
will become on.
The End light will become on when the
selected washing programme ends.

Cancelling the programme

1. Press and hold the Start / Pause /
Cancel key for 3 seconds to cancel the
programme.
2. Release it when the Washing and
Drying lights start flashing. Water in
the machine will be discharged in 45
seconds. The programme will have
been cancelled once the Washing and
Drying lights go off and the End light
becomes on. Then, you can select and
operate a new programme.
C
There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces
being washed depending on the
step in which the programme
has been cancelled.
C
When you set the Programme
Selection Knob to "Off" position,
the washing programme will
end and the machine will be
ready for a new programme
selection. If you end the
washing cycle this way, water
and detergent may remain in
the machine.
Dishwasher / User's Manual