2 to 11 IMPORTANT SAFETY INFORMATION FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. MESURE DE SÉCURITÉ: Ne pas entreponer ni utiliser d´essence ni autres vapeurs ou liquides inflammables á...
- For any goods shipped prepaid by MVP Group Corp., and the goods are damaged and/or lost in transit, please call the Logistics Department at MVP immediately (1-888-275-4538) - MVP Group will not be held responsible for damages that are not notated on the BOL or not reported within 5 business days of being delivered.
Page 4
4 to 11 The installation must conform with local codes, or in the absence of local codes, to the national fuel gas code, ANSI Z223.1 (or latest addenda). The Appliance and its individual shut off valve must be disconnected from the gas supply piping system during any pressure testing of that system in excess of ½...
5 to 11 (1) Turn the oven thermostat knob to “off” and wait 5 minutes. (2) Remove the oven’s lower kick plate by lifting up and out. This exposes the pilot safety valve and the igniter button. (3) Make sure any accumulated gas has dispersed. Since propane gas is heavier than air, check near the floor area for the odor of propane gas before attempting to light any pilot burners.
6 to 11 PERIODIC: Remove open burners and clean with warm water and wire brush. Make sure the ports are not clogged. Check valves and lubricate, if necessary. Consult your service agency or local Gas Company. STAINLESS STEEL PARTS Do not use steel wool, abrasive clothes, cleansers or powders to clean stainless steel surfaces. All stainless steel parts should be wiped regularly with hot soapy water during the day and a stainless steel liquid cleaner at the end of the day.
7 to 11 GAS CONNECTION The gas supply (service) line must be the same size or greater than the inlet line of the appliance. SIERRA appliances use a ¾” NPT inlet. Pipe joint compound must be resistive to Natural or LP gas. For equipment using propane gas do not install supply lines with a diameter less than ½...
Page 8
8 to 11 This installer supplied valve must be in the gas service line ahead of the appliance regulator in the gas stream and in a position accessible in the event of an emergency. LOCATION • Installation of the equipment should be performed by qualified, certified, and authorized personnel who are familiar and experienced with local installation codes.
Page 9
9 to 11 Air movement should be checked during installation. Air openings or baffles may have to be provided in the room, if pilot or burner outage problem persists. RATING PLATE Information on this plate includes the model, serial number, BTU / hour input of the burners operating gas pressure in inches WC, and whether the appliance is orifices for natural or propane gas.
If a defect in material(s) or workmanship is detected, or found to exist within the stated period above, MVP Group Corp., at its sole discretion, shall either repair or replace any original part which has proven to fail within the machine, providing that the equipment has not been altered or tampered with in any manner, has been installed correctly as per the owner’s...
Page 11
11 to 11 (514) 737-9701 (888) 275-4538 service@mvpgroupcorp.com 5659 Royalmount Ave Montreal, QC, Canada H4P 2P9 (786) 600-4687 (844) 218-8477 service@mvpgroupcorp.com 12000 Biscayne Blvd, Suite #108 Miami, FL, United States 33181...
Need help?
Do you have a question about the Sierra SRS-24 and is the answer not in the manual?
Questions and answers