Advertisement
Operation
U nit start / stop
Remote controller
1. Unit start
Press ON/OFF on the remote controller, unit starts.
2.Select temp.setting
button
Press
/
Every time the button is pressed, temp.setting
increase 1
o
C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
decrease 1
o
C,if kept depressed, it will
decrease rapidly
Select a desired temperature.
3.Fan speed selection
Press FAN button. For each press, fan speed
changes as follows:
Remote controller:
L OW
MED
Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
Remote
Operation
Display Board
Controller
Mode
AUTO
COOL
DRY
HEAT
FAN
nothing
1
2
3
2
Display
circulated
HI
AUTO
Note
Under the mode of auto operation, air conditioner will
automatically select Cool or Heat operation according
to room temperature.
When FAN is set to AUTO, the
air conditioner automatically adjusts the fan speed
according to room
temperature.
Cooling only unit do not have displays and functions
related with heating
In DRY mode, when room temperature becomes
lower than temp.setting+ 2
o
C,unit will run intermittently
at L OW speed regardless of FAN setting.
In HEAT mode,warm air will blow out after a short
periodof the time due to cold-draft prevention function.
In FAN operation mode, the unit will not operate in
COOL or HEAT mode but only in FAN mode ,AUTO is
not available in FAN mode.And temp.setting is disabled.
When FAN is set to AUTO, the air conditioner automatically
adjusts the fan speed according to room temperature.
In FAN mode,SL EEP operation is not available.
A ir F low D irection A d j u stm ent
1.V ertical flap
Pos.1
Pos.2
Pos.3
Pos.4
( Autoswing)
Pos.5
2.Press
button. changes as follows: Pos.4
Press
button again , vertical flap will stop over
present position, the swing function will be cancelled．
3.Press
button to choose the Pos.2 and Pos.3.
Cautions:
When adjusting the flap by hand,turn off the unit.
When humidity is high,condensate water might occur
at air outlet if all vertical louvers are
right.
It is advisable not to keep horiz ontal flap at downward
position for a long time in COOL or DRY
otherwise, condensate water might occur.
Note:
When restart after remote turning off, the remote
controller will automatically
set swing position.
Remote controller
COOL /DR Y /AUTO( Initial state ) :
HEAT( Initial state ) :
( no)
adjusted to left or
mode ,
return to the previous
2
Advertisement
