Page 1
A/C MANIFOLD GAUGE SET Item Number W89730 OWNER'S MANUAL WARNING: USE ONLY R-134A REFRIGERANT WITH THE A/C MANIFOLD GAUGE SET WARNING TO PREVENT EXPLOSION, SERIOUS INJURY, AND DEATH: • Service of air conditioning systems must be done only by trained and experienced technician to avoid overfilling.
SPECIFICATIONS: Blue (Low) Gauge............................... 0-120 PSI Blue Hose ............................. 1/4 in. FFL x 50 in. Red (High) Gauge .............................. 0-500 PSI Red Hose.............................. 1/4 in. FFL x 50 in. Yellow Hose ............................1/2 in. ACME x 50 in. Gauge Accuracy ................................+/-2% Specifications are subject to change without notice.
COMPONENTS AND FUNCTIONS 1. The Red HP Gauge (3) is used to measure high pressure compressor discharge side pressure. 2. The Blue LP Gauge (5) is used to measure low-pressure side suction or pressure. 3. The Manifold Valves (11) control the flow of refrigerant to and from the Yellow Hose (18), also called the Charge Hose. 4.
Page 4
OPERATION CONTINUED WARNING: TO PREVENT EXPLOSION, SERIOUS INJURY, AND DEATH: Do not open the red HP Manifold Valve unless requested to do so during the recovery/evacuation procedure. Refrigerant is under great pressure. Attempting to add refrigerant through the HP side of the system may cause the refrigerant can to explode. Note: Throughout this manual: HP means High-pressure LP means Low-pressure...
Page 5
DIAGNOSTIC CHECK 1. Close both Manifold Valves (11) by turning CW. 5. AFTER: Close both Coupler Valves (22, 23) by turning CCW. a. Close both Coupler Valves (22, 23) by turning CCW. 2. CONNECT HOSES: a. Connect one end of the Blue Hose (19) to the b.
Page 6
DIAGNOSTIC CHECK CONTINUED 5. AFTER: a. Shut off the refrigerant recovery system / vacuum pump when the vacuum level reaches the manufacturer’s recommended level. b. Close both Coupler Valves (22, 23) by turning CCW. c. Disconnect the Couplers (22, 23) from the A/C system.
CARE AND MAINTENANCE before further use. TO PREVENT SERIOUS INJURY FROM TOOL Do not use damaged equipment. FAILURE: Do not use damaged equipment. If abnormal noise, vibration, or leaking air occurs, have Periodically, clean with a damp cloth using a mild the problem corrected before further use.
LIMITED WARRANTY PERFORMANCE TOOL® extends only the following warranties, and only to original retail purchasers. These warranties give specific legal rights. Except where prohibited by local law, the law of the State of Washington governs all warranties and all exclusions and limitations of warranties and remedies.
Need help?
Do you have a question about the W89730 and is the answer not in the manual?
Questions and answers