Included In The Package; Getting Started; Battery Removal And Installation - VTech Switch & Go Dinos Bash the Triceratops Parents' Manual

INCLUDED IN THE PACKAGE

• Switch & Go Dinos
• Parent's Guide
WARNING:
All packing materials such as tape, plastic sheets,
packaging locks, removable tags, cable ties, cords
and packaging screws are not part of this toy and
should be discarded for your child's safety.
NOTE:
Please keep this parent's guide as it contains important
information.

GETTING STARTED

BATTERY REMOVAL AND INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a coin or a
screwdriver to loosen the screw.
Then, remove the cover.
3. If used or spent batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AA (LR6/AM-3) batteries
following the diagram inside the
battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
Bash the Triceratops
®
of
children.
4