Electrolux E30EW75GSS Specifications page 6

30" Combination Installation –
Built-In Microwave/Single Wall Oven
For detailed product dimensions
and installation specifications, refer
to model-specific product page and
installation guide on web
30" Built-In
Microwave Cutout
For model:
E30MO65GSS
30" Electric Single
Wall Oven Cutout
For models:
E30EW75GPS
E30EW75GSS
* Minimum 3
clearance required
from bottom of
Built-In Microwave
cutout to top edge of
Wall Oven's faceplate,
leaving a 2" visible
gap between both
product faceplates
** Critical dimension –
MUST be applied
30" Combination Installation Specifications
Always consult local and national electric codes.
•
(Refer to product-specific electrical specifications on this page.)
Minimum 24"deep cutout dimension is critical for proper combination
•
installation, to ensure that each built-in product's faceplate will fit
flush against cabinet front.
Bases must be level and cabinet front must be square.
•
Minimum 4-1/2" required distance from bottom of Wall Oven cutout
•
to floor, 31" suggested.
Respect critical dimensions as noted for proper installation of built-In
•
products.
Minimum 23-1/4" clearance needed for Wall Oven door depth
•
when open.
Electrolux Major Appliances, N.A.
250 Bobby Jones Expressway
USA
• •
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
MO_EW INST 09/09
7
19 / "min.
8
20 3 / "max.
8
2"
(visible
gap)*
28 1 / "min.
2
28 7 / "max.
8
1
/ "
8
31"
suggested
distance
4 1 / "
2
min.
required
Augusta, GA 30907 1-877 -4electrolux (1-877 -435-3287)
•
1-800-265-8352
•
24" min. 30" min.
5"
11 1 / "
2
26 1 / "min.
2
27" max.
24" min.**
1
28 / "min.
(critical
2
29" max.
dimension)
2" min.
Bottom cutout
edge must be
finish cut
30" Built-In Convection Microwave Specifications
Product Weight – 60 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.55 kW
•
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Amps @ 120 Volts = 13 Amps
•
Consult local building code in the event that cutout opening may
•
be required to be enclosed with sides, ceiling and rear partition.
Full base of solid plywood or similar material required, capable of
•
supporting 100 Lbs.
Minimum 3-1/8" clearance required from bottom of Built-In Microwave
•
cutout to top edge of Wall Oven's faceplate, leaving a 2" visible gap
between both product faceplates.
30" Electric Single Wall Ovens Specifications
Product Weights – (E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.
•
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
•
AC only electrical supply with ground required on separate circuit fused
on both sides of line.
Connected Load (kW Rating) @ 240 / 208 Volts = 4.0 / 3.0 kW
•
Amps @ 240 / 208 Volts = 16.6 / 14.4 Amps
•
Full oven base of solid plywood or similar material required, capable of
•
supporting 200 Lbs.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
electroluxicon.com
•
electroluxicon.ca
•
© 2009 Electrolux Home Products, Inc.
120V/60Hz
grounded electrical
outlet should NOT
be located within
shaded area
Full plywood base
required to support
100 lbs.
4"x 4" opening
to route armored
cable
Full base required
to support 200 lbs.
3" max.
Electrical junction
box location
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Printed in the U.S.A.