Asus TUF H370-PRO GAMING Manual page 15

• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.
• Chassis intrusion connector (2-pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the two
pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <Del> key during the boot process and enter
BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
USB 2.0 connectors (10-1 pin USB1213, USB1114)
Connect a USB module cable to any of these
connectors, then install the module to a slot opening at
the back of the system chassis. These USB connectors
comply with USB 2.0 specifications and supports up to
480Mbps connection speed.
AURA RGB header (4-pin RGB_HEADER)
These connectors are for RGB LED strips.
Serial port connector (10-1 pin COM)
This connector is for a serial (COM) port. Connect the serial
port module cable to this connector, then install the module
to a slot opening at the back of the system chassis.
ASUS TUF H370-PRO GAMING
CLRTC
PIN 1
USB1213 USB1114
PIN 1 PIN 1
COM
PIN 1
1-5