SmartPool SUNHEATER S210U Installation & Operation Manual

Advertisement

Quick Links

INSTALLATION &
OPERATION MANUAL

How Solar Pool Heating Works

• Using your pool pump, water
is automatically pumped
through the solar collectors.
• As sun shines on the collector,
the water is then heated as it
moves through it.
• The heated water is returned
back to the pool, through
your return lines.
• You enjoy your own
heated pool with no
fuel costs.
PLEASE READ THIS MANUAL CAREFULLY. YOUR ENJOYMENT OF YOUR SOLAR HEATED POOL
AND YOUR WARRANTY ARE AFFECTED BY HOW YOUR SOLAR HEATING SYSTEM IS INSTALLED
CAUTION:
a) Solar collectors are often installed on the roofs of buildings. Unless you are very familiar with working
on roofs and have the proper ladders and safety equipment for such work, you should hire someone with
the necessary experience to do the installation. Failure to observe safe practices on a roof or other elevated
structure may result in falling, leading to serious injury to you.
b) When installing collectors on the ground, do not build a rack support that could allow children access
into the pool.
Product Number S210U
• Water is heated as it moves through the many
• Tube and web design traps heat and catches
• Tough polypropylene material won't rust, corrode
www.smartpool.com
Why Solar Heat Works Best
Collector Cross Section
tubes in the solar collectors.
light as the sun moves across the sky.
or scale. Plus, the collector is reversible.
1.1.A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUNHEATER S210U and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SmartPool SUNHEATER S210U

  • Page 1 Failure to observe safe practices on a roof or other elevated structure may result in falling, leading to serious injury to you. b) When installing collectors on the ground, do not build a rack support that could allow children access into the pool. www.smartpool.com 1.1.A...
  • Page 2 • For a ground mount installation you will require 2 hoses - one that will reach from the pool equipment to the collector and one that reaches from the collector back to the pool. • For a rack mount installation you will need SmartPool’s mounting kit SK-43. For high wind areas you will need one SK-34 for each collector. USE ONLY SMARTPOOL-APPROVED MOUNTING KIT SK43 AND FOLLOW THE DIRECTIONS PROVIDED.
  • Page 3 SunHeater. Please Note: Small holes in collector (see photo at right) are NOT to be used for mounting. Use only SmartPool- approved mounting kit SK43 and follow the directions provided. Failure to comply will void your warranty.
  • Page 4 13. Turn on the pump. Check for leaks and tighten the connections that need attention. Note:Upon start-up you will see air bubbles come through the return hose. This is normal and will stop after all the air has been purged from the solar heating system. www.smartpool.com...
  • Page 5 You can leave the collectors in place (as long as they are completely drained) and they will withstand even the harshest winters. SmartPool recommends that you store your collectors inside in a warm dry place.
  • Page 6 SmartPool, Inc., subject to the provisions of the limited warranty stated above, and the exclusions and limitations set forth below. SmartPool LLC will, pursuant to the terms of this warranty, at its sole option. either repair the collector at a nominal charge to the owner, or replace the collector per the pro-rated provisions stated herein.
  • Page 7 www.smartpool.com...
  • Page 8 www.smartpool.com...

Table of Contents