Adjusting The Amount Of Rinse Aid; End Of Programme; Water Cut-Off Warning; Overflowing Warning - Beko BDFN15430W User Manual

Adjusting the amount of rinse
aid
1. After turning on the machine, press
and hold Time Delay and P keys
simultaneously for 3 seconds to enter
the settings menu.
2. Press P key until the drying indicator
starts flashing
3. Set to the appropriate level with the
Time Delay key.
4. Press the On/Off key to save.
No rinse aid dispensed in P:1 position
1 dose of rinse aid is dispensed in P:2
position.
2 doses of rinse aid are dispensed in P:3
position.
3 doses of rinse aid are dispensed in P:4
position.
4 doses of rinse aid are dispensed in P:5
position.

End of programme

End of Programme indicator will light up
once the washing programme is over.
1. Press the On/Off key to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the socket.
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your
dishes will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.

Water cut-off warning

If mains water is cut or water inlet tap is
turned off the machine cannot take water
in and P2 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored P2
icon will disappear after a while and the
washing programme resumes.

Overflowing warning

If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and P1
icon will flash on the Programme indicator.
As long as the overflowing continues safety
algorithm will be active and try to discharge
the water. If overflowing stops and safety is
assured, P1 icon will disappear. If P1 does
not disappear, there is a permanent fault. In
this case the authorised service should be
contacted.
37/EN