Zanussi ZUNN26FW User Manual page 14

Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
DEMO appears on the display.
A or or
shown instead of numbers on
the temperature display.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
14
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The "FastFreeze function" is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
The appliance is in demonstra-
tion mode.
Temperature sensor problem.
symbol is
Possible cause
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func-
tion" manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "FastFreeze function"
section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "FastFreeze function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.
Keep the OK key pressed for
approximately 10 seconds until
a long sound is heard and the
display turns off for a short
time.
Contact the nearest Author-
ized Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).