Zanussi ZUNN26FW User Manual page 13

Problem
The compressor operates con-
tinually.
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
Side panels of the appliance
are warm.
There is too much frost and
ice.
Possible cause
The door is left open.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The FastFreeze function is
switched on.
The compressor starts after a
period of time.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
This is a normal state caused
by operation of the heat ex-
changer.
The door is not closed correct-
ly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
Solution
Close the door.
Refer to "Control Panel" chap-
ter.
Wait a few hours and then
check the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door"
section.
Refer to "FastFreeze function"
section.
This is normal, no error has oc-
curred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of the
door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products better.
Refer to "Control Panel" chap-
ter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
13