Connection To The Drain; Adjusting The Feet - Beko BDF1630X User Manual

Installation
Permitted water temperature: up
to 25°C
The dishwasher should be connected to cold
water inlet.
Do not use old or used water inlet hose
•
on the new product. Use the new water
inlet hose supplied with the product.
Connect the water inlet hose directly
•
to the water tap. Pressure coming from
the tap should be minimum 0.3 and
maximum 10 bars. If the water pressure
exceeds 10 bars, a pressure relief valve
should be installed in between.
Open the taps completely after making
•
the connections to check for water
leaks.
C
Use a screw-on hose connector
to connect the water inlet hose
to a water tap with a ¾ inch
external thread. If required, use
a filter insert to filter deposits
from the pipes.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.

Connection to the drain

Water discharge hose can directly be
connected to the drain hole or sink's
drainage. The length of this connection must
be min. 50 cm and max. 100 cm from the
floor. A discharge hose longer than 4 meters
causes dirty washing.
10 /42 EN
Attach the water discharge hose to the
drainpipe without bending it. Tightly fix the
water discharge hose to the drainpipe in
order to prevent any dislocation of the water
discharge hose during operation of the
product.
C
Drainpipe must be connected
to the sewage system and it
should not be connected to any
surface water.

Adjusting the feet

If the door of the product cannot be closed
properly or if the product swings when you
push it slightly, then you need to adjust
the feet of the product. Adjust the feet of
the product as illustrated in the installation
manual supplied with the product.
A
Diswashers door must be
aligned properly otherwise hot
steam can escape! Danger of
serious burns, other injury or
may damage furniture.
Dishwasher / User's Manual