Download Print this page

Fenix WT16R Operating Instructions, Technical Parameters page 3

Advertisement

The light memorizes the last selected output. When turned on again the previously used output 
will be recalled.   
 
Charging   
1.  First  switch  off  the  light  and  plug  the  USB  A  socket  of  the  charging  cable  into  an  electrical 
outlet, then connect the USB Type‐C socket of the charging cable to the light. 
2. The indicator will display red while charging, and will turn to green when fully charged.   
3. Be sure to close the anti‐dust cover once charging is completed. 
Note: 
1. Low output level of both modes and Yellow Flash are available when charging. 
2. The normal charging time is approximately 1 hour and 40 minutes with a 5V/2A adapter from 
depletion to full charging.   
3. Recharge a stored light every four months to maintain optimum performance of the battery. 
 
Battery Level Indication   
With the light switched off, single click the switch to check the battery status, the indicator will 
last for 5 seconds.   
Green light on: saturated 100% ‐ 85% 
Green light flashes: sufficient 85% ‐ 50% 
Red light on: poor 50% ‐ 25%   
Red light flashes: critical 25% ‐ 1% 
 
Intelligent Overheat Protection 
 
The light will accumulate a lot of heat when used on High modes for extended periods. With the 
light  switched  on,  if  High  are  being  selected  for  over  5  minutes,  the  spotlight  will  gradually 
downshift to 200 lumens and the floodlight will gradually downshift to 150 lumens..   
 
Low Voltage Warning   

Advertisement

loading