Table of Contents
Advertisement
After assembling the components as shown in figure 2, position the saw bar square to the log, at the correct height
with clearance between the bar plate and the side of the largest log and weld down solidly (Fig. 3). The dimensions
in figure 3 can be changed as required for your installation. Position the bar oil pump above the bar plate port when
retracted, and below the bar oil tank with the bar oil tank positioned so it is easy to clean and fill. You will need to
fabricate and position a lever to feed the saw through the cut and return it to the retracted position. You will need
to make guarding to protect the operator from sawdust and touching the chain.
Fig. 3
5
Advertisement
Table of Contents
