Related Manuals for 6K Products DH0657
Summary of Contents for 6K Products DH0657
-
Page 1: Cover Page
OPERATION AND PARTS MANUAL DH0657 24G36 Simple Saw Assembly Information subject to change without notice. -
Page 2: Safety Precaution
⇒ The information in this manual is subject to change without notification. ⇒ This manual is intended for safe operation and maintenance of the 6K Products, 24G36 Simple Saw Assembly. 6K Products, welcomes any and all suggestions on how to improve this manual or... -
Page 3: Table Of Contents
Table of Contents Cover page ..................................1 Safety Precaution ................................. 2 Table of Contents ................................. 3 Introduction .................................. 4 Warranty ..................................4 Installation ..................................4 Hydraulic Connections ..............................6 Chain Tension and Sharpening ............................. 7 Sprocket Removal and Replacement ..........................8 Operating Instruction .............................. -
Page 4: Introduction
Introduction Thank you for purchasing a 6K Products product. Our goal is to provide quality products for your job. This manual contains warranty information, installation information, operation instructions, parts ordering information, and service contact information. Warranty This 6K Products product carries a one year or 2000 hour warranty on the 6K Products designed and built components covering material and workmanship. - Page 5 After assembling the components as shown in figure 2, position the saw bar square to the log, at the correct height with clearance between the bar plate and the side of the largest log and weld down solidly (Fig. 3). The dimensions in figure 3 can be changed as required for your installation.
-
Page 6: Hydraulic Connections
Hydraulic Connections The hydraulic requirements to operate the saw are 23 to 25 gallons per minute at 2000 psi from a fixed displacement hydraulic pump. You must install the pressure relief valve between the hydraulic pump and the selector valve to keep from damaging the hydraulic pump. Figure 4 shows hose connections for correct operation. Fig. -
Page 7: Chain Tension And Sharpening
The Power Beyond Port can connect to another valve for conveyor and clamp, or must go to the filter and tank. The return hose can be #12 or 3/4” diameter for the first two feet. If a longer hose is required it must be #16 or 1” up to twenty feet. -
Page 8: Sprocket Removal And Replacement
Sprocket Removal and Replacement The chain saw sprocket is connected to the shaft with a tapered bushing. To remove the sprocket remove the Cap Screws (Fig. 6, Item 3) and screw them into the Threaded Holes, tighten up to 36 inch pounds to push the Sprocket (Fig. -
Page 9: Operating Instruction
Returning the saw to the up stop will stop the saw chain. Parts and Service Information For parts and service contact 6K Products. Our hours of operation are 8:00 AM to 4:30 PM, Monday through Friday, Pacific Time excluding holidays. -
Page 10: Saw Assembly
DH0657 SIMPLE SAW ASSEMBLY... -
Page 11: Pivot Assembly
DH0321 PIVOT ASSEMBLY... -
Page 12: Selector Valve Assembly
DH0326 SELECTOR VALVE ASSEMBLY...