Steinbach Speed Clean 75 Installation And Operating Instructions Manual page 12

1. General information
1.1 General
The filtration system consists of a filter container constructed of high-grade polypropylene (PP). It is seamless, manufactured as a single unit
(absolutely corrosion resistant and resistant to commercially available swimming pool chemicals). It is equipped with a container drainage
system, pressure gauge, built-in container components, e.g. bottom strainer for even water distribution and a stable PE separation wall between
the filter and the fresh water chamber. The filter container comes ready to plug-in and is supplied with a user-friendly 6-way central valve
integrated into the container cover, a TÜV/GS approved self priming filter pump with a plastic pre-filter and a plastic pallet, for ready on site
mounting.
The system is constructed of high-grade materials to strict technical standards, and subject to a final inspection.
This handbook contains assembly, installation, start-up, maintenance, repair and servicing instructions.
Safety notes and callout boxes should always be observed.
1.2 Callout boxes
In this technical manual, the callout boxes, CAUTION, ATTENTION and NOTE have the following meanings:
CAUTION:
ATTENTION:
NOTE:
1.3 Warranty
The manufacturer warranties safe operation and reliability only under the following conditions:
The filter system is installed and operated according to the assembly and operating instructions.
Only original replacement parts are used.
(consumable parts do not fall under the warranty)
Expendable parts do not fall under the warranty. These include
All O-rings (40x5 mm O-ring for filter cover, 105x5 mm O-ring for pump cover, 58x6 mm O-Ring for housing
50x3 mm O-rings for hose connexions, 6x2 mm O-rings for screws)
Pressure gage
Strainer basket (rough) with handle
Mechanical seal, complete
1.4 Safety notes
Your filter pump was constructed and tested according to the European standard, EN 60335-2-41 Safety of Electrical Devices for Household
and Similar Uses - Special Requirements for Pumps, and left the manufacturing plant in technically operational condition.
In order to maintain this condition and ensure safe operation, the user should observe the notes and product information contained in this
technical handbook. If there is any indication that safe operation is no longer possible, the device is to be disconnected from the power supply
and secured against accidental use.
This is the case when:
The device has visible damage
The device no longer appears functional
After long periods of storage in poor conditions
1.5 Damage during delivery
We packed your filter system carefully and professionally for delivery.
Please check to ensure that the package is undamaged and that the delivery is complete. Damage during delivery must be immediately
reported to the shipper.
1.6 Filter system scope of delivery
6-way central valve with container cover, pressure gauge, tension ring, container, spiral pressure hose with hose clamps, operating instructions,
filter pump mounting screws, filter pump, filter pallet, reserve retaining pin for lever (6-way valve), Pump adapter 32/38 mm
This heading is used when injury or accidents may occur if the operating instructions, work instructions, work
procedures, etc. are either not strictly carried out, or are not carried out at all.
This heading is used when damage to the device may occur if the operating instructions, work instructions, work
procedures, etc. are either not strictly carried out, or are not carried out at all.
This heading is used to call attention to special items of information.
- 1 -