Related Manuals for Hayter 133E
Summary of Contents for Hayter 133E
- Page 1 M10/30 HERITAGE TRACTOR CODE 133E INSTRUCTION BOOK CODE SERIAL NO. PART NO: 111-1013 (rev.A.) 133E 270000001 ISSUE 01/22/07 1740517...
-
Page 2: Danger: No Step
4 (17x47) 5 (1001054) 8 (26x270) 8 (26x270) 6 (2x82) 6 (2x82) 7 (14x79) 1740517... -
Page 3: Danger: Keep Feet And Hands Away From Rotating Blade
1740517... -
Page 4: Declared Airborne Sound Power Level Of 100
1740517... -
Page 5: Db(A) Is In Accordance With Directive 2000/14/Ec
1740517... -
Page 6: Danger: Disconnect Spark Plug Wire
1740517... -
Page 7: Warning: Hot Surface
1740517... -
Page 8: Warning: Maximun Loading When Using
150N 327349 1001054 26x270 17x47 690604 2x82 14x79 1740517... -
Page 9: Limited Warranty
LIMITED WARRANTY Hayter Limited warrants to the original user / purchaser that this unit shall be free from defects in material and workmanship under normal use and service for a period of three years from the date of purchase. The manufac- turer of the engine furnish their own warranty and services are provided through their authorised network (Refer to “Engine Warranty Statement”). -
Page 10: Table Of Contents
Vibration Emission according to BS EN 1033: Steering Wheel 4,18 m/s 2850 Values determined with operator in operating position when the machine was operated stationary on a concrete surface at 2850 min- -1. 133E 270000001 Declared airborne noise emissions in accordance with Directive 2000/14/EC, Annex VI. -
Page 11: Owner's Information
OWNER’S INFORMATION Thoroughly inspect the area where the nor allow anyone near the machine while in equipment is to be used and remove all ob- operation. jects which may be thrown by the machine. Know your product: If you understand the unit 10. -
Page 12: Assembly
If you do not have a battery Fill the fuel tank with petrol. 3. Set the console (2) on the frame. Reach charger, have an authorised Hayter dealer under the console (2) and slip the end of the Check the level of the mower hous- charge the battery. -
Page 13: Operation
Use the blade rotation control (1) to engage thorised Hayter dealer. 2. When you ride on a sidewalk or road, move the blade(s). the lift lever (5) to the highest position and 1. -
Page 14: (Figure 30)
Add Petrol 4. Slowly move the blade rotation control to the 4. Keep the blade(s) sharpened. Worn blades ENGAGE position. will cause the ends of the grass to turn WARNING: Always use a safety brown. 5. Push the clutch/brake pedal completely for- petrol container. -
Page 15: Maintenance
See the au- loose nut or blade can cause an 4. Follow the Maintenance section to keep the thorised Hayter dealer in your area. Every three accident. unit in good operating condition. years, have an authorized service person in- spect the blade or replace the old blade with an 9. - Page 16 “How To Replace The Motion Drive Belt”. blies. Correct replacement parts and assist- 4. Fasten the red cable (5) to the positive (+) ance are available from an authorised Hayter terminal (4) with the fasteners as shown. dealer. 5. Fasten the black cable (8) to the negative (--) terminal with the fasteners as shown.
- Page 17 4. A correct replacement part or assistance is with the square key (10). Slide the rear Lubricate with grease gun. available from an authorised Hayter dealer in wheel (12) on the axle (9). Apply grease with a brush to your area.
-
Page 18: Trouble Shooting Chart
TROUBLE SHOOTING CHART 3. Clean the air filter. 7. Clean the extension tube and the connector tube (applies only to model with rear dis- 4. Replace the fuel filter. charge grass bag). PROBLEM: The engine will not start. PROBLEM: The engine stops when the PROBLEM: The mower housing does 1. - Page 19 1740517...
- Page 20 1740517...
Need help?
Do you have a question about the 133E and is the answer not in the manual?
Questions and answers