FL38
(LC-15A2L)
1. Insert your finger into the center of the terminal cover
and pull it toward you to detach the terminal cover.
Remove the screws installing a stand.
2. Remove the four screws "1" and one screw "2".
3. Open the cabinet B by approx. 45˚ from the bottom
of the cabinet (stand side).
4. Remove the lead wire from the cable clamp "3".
5. Remove the power connector "4".
6. Remove the connector "5" from the light reception
unit.
7. Remove the lead wire from the cable clamp "6".
8. Remove the speaker connector "7".
9. Remove the FFC from the FFC connector "8" on the
main PWB.
10. Remove the connector "9" from the switch PWB.
11. Remove the right and left speaker connectors "10"
on the terminal PWB.
Terminal Cover
REMOVING OF MAJOR PARTS
<<Disassembly of the main PWB>>
1. Disconnect the flexible cable connectors "11" and
"12" from the LCD panel.
2. Disconnect the cable connectors "13" and "14" from
the fluorescent lamp.
3. Remove the four screws "15".
<<Disassembly of the terminal PWB>>
1. Remove the five screws "16".
2. Remove the two screws "18". Remove the cover "17".
Take them out of the cabinet holes.
<<Cabinet A side>>
Cabinet A
<<Cabinet B side>>
Cabinet B
6