Thule Outrigger II 847 Manual
Hide thumbs
Also See for Outrigger II 847:
- Installation instructions manual (6 pages) ,
- Manual (6 pages)
Advertisement
Quick Links
part
A
stop
B
end cap
C
nut
D
bolt
E
hex key
1
2
OUTRIGGER
PARTS INCLUDED
description
NOTE: OUTRIGGER II CAN BE MOUNTED TO THE FRONT OR REAR LOAD BAR.
2"
II
™
847
B
A
INSTALLATION
• Remove standard end cap from load bar.
• There must be minimum 2" of load bar outside of foot for
installation. Adjust load bar as necessary.
D
C
part number
938-0600-54
919-0616-54
E
qty.
853-5840
2
853-5838
1
1
1
853-0930
1
Advertisement
Related Manuals for Thule Outrigger II 847
Summary of Contents for Thule Outrigger II 847
- Page 1 OUTRIGGER ™ PARTS INCLUDED part description part number qty. stop 853-5840 853-5838 end cap 938-0600-54 bolt 919-0616-54 hex key 853-0930 INSTALLATION NOTE: OUTRIGGER II CAN BE MOUNTED TO THE FRONT OR REAR LOAD BAR. • Remove standard end cap from load bar. 2"...
- Page 2 • Loosen screw on Outrigger II end cap. NOTE: Heavy corrosion inside load bar could prevent smooth operation. Clean as necessary. • With curved surface on top, insert into open load bar. • Slide Outrigger II end cap onto load bar. •...
- Page 3 • Push arm into load bar and close cover onto end cap to secure. NOTE: Test by pulling out on cover without lifting cover up to ensure it stays in place. • Gradually pull out bar. NOTE: To prevent accidental contact, protect vehicle surface while loading a boat.
- Page 4 • Push extended bar into load bar and close cover onto end cap to secure. NOTE: Pull out on cover to ensure it holds to end cap. FOLLOW ACCESSORY INSTRUCTIONS TO SECURE BOAT TO VEHICLE.