LG WTG16032VH Service Manual page 32

Please ensure any foam transit restraint has been removed from the machines packaging before
operating your machine.
1
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the
right and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is sug-
gested.
NOTE
If the washer is installed on an uneven, tilted, or weak timber floor causing excessive vibration,
a spin failure or "U E " error can occur.
It must be placed on a firm and level floor to prevent spin failure.
2
Check that the machine is level
Open the lid and look from above to see if it is
same as shown.
3
Leveling the machine
Lift the front of the washing machine and twist
the appropriate Adjustable Leg until the surface
bubble is (some models only) located in the
center.
※ Installing the Anti-Rat Cover (optional on some models): Insert the anti-rat cover from the rear of the
machine and secure it with the screw provided.
BACK
Caution
If an extension cord or power board is used, ensure it is positioned so that it is not exposed to water or
moisture. This machine should be connected to a 230~240v town mains power outlet.
more than 10 cm
more
than
2 cm
Top view of the machine
BACK Adjustable legs
SETTING SCREW
BACK
BACK
ANTI-RAT COVER
32
more than
2 cm
SETTING SCREW
ANTI-RAT COVER
SETTING SCREW
SETTING SCREW
ANTI-RAT COVER
ANTI-RAT COVER