4-room digital amplifier with eaudiocast (19 pages)
Summary of Contents for SNAP Episode engineered EA-MINI-2D-35
Page 1
EA-MINI-3D-35 SWITCH POSITION CONTROL MONO FULL IN 1 DOWN LEARN STEREO HP 60Hz IN 2 RECEIVER SUB OUT IR OUT 100-240V~50/60Hz 1.6A SPEAKER OUTPUTS AUDIO EQUIPMENT +5V GND R+ R- L+ L- E363665 STATUS RESET IR IN 1 2 3 4 5 ANALOG IN DIGITAL IN SWITCHES...
EA-MINI-xD-35 Amplifiers Control Protocol Table of Contents 1. Overview .......................... 3 2. IR Connections and Setup ....................3 2.1 IR Connections and Controls ........................3 2.1.1 IR In Port ............................3 2.1.2 IR Receive/Control Dip Switch ....................3 2.1.3 IR Out Port ........................... 3 3.
EA-MINI-xD-35 Amplifiers Control Protocol 1. Overview This protocol provides the information required to control an EA-MINI-xD-35 amplifier via IR through a connected IR receiver or Automation System. Follow the instructions carefully to ensure that IR will function at the highest level, and not cause damage to the amplifier or other components.
EA-MINI-xD-35 Amplifiers Control Protocol 3. IR Applications 3.1 In-Room IR Receiver with IR Remote To control the amplifier with an in-room IR remote (commands transmit directly from the remote): Set dip switch 1 to the DOWN position. Connect the IR Receiver to the IR In port. Position the receiver so that commands are received reliably.
Need help?
Do you have a question about the Episode engineered EA-MINI-2D-35 and is the answer not in the manual?
Questions and answers