Powermate PRTT212 Operator's Manual page 9

Assembly
(Continued)
• Save all instructions
Attach Lower Handle
(See Figure 4)
1 . Loosen the lower handle bolts, if required .
2 . Align the lower handle holes to the middle height
adjustment holes in the transmission cover and install
the M10 X 25mm bolts, flat washers, lock washers and
nuts . Tighten all four bolts at this time .
Attach Upper Handle (See Figure 5)
1 . Slide the upper handle down over the lower handle and
align the holes .
2 . Insert the saddle bolts into the holes as shown and secure
with the handle knobs .
3 . Tighten the handle knobs securely .
4 . Secure control cables to handle using cable ties .
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
Handle Knobs
Saddle Bolts
Copyright © 2019 MAT Engine Technologies, LLC
8
Height
Adjustment
Holes
Transmission Cover
Lower Holes
Figure 4
Handle Knobs
Figure 5