Technical Service - Powermate PRTT212 Operator's Manual

Maintenance
• Save all instructions
D
How to Prepare for Storage
WARNING
Never store the tiller indoors with fuel in the fuel tank . Never store in an enclosed, poorly ventilated area where fumes
could reach an open flame, a spark or a pilot light as on a furnace, water heater or clothes dryer. Allow engine to cool
before storing unit .
WARNING
Do not remove gasoline while inside a building, near a fire, or while you smoke. Gasoline fumes can cause an explosion
or a fire.
NOTE: A yearly checkup or tune-up at an authorized service center will make sure that the tiller will provide maximum
performance for the next season .
When the tiller is put in storage for thirty days or more, the following steps should be followed to make sure the tiller is in good
condition the next season . To prevent fuel gum deposits and corrosion in the unit's carburetor and fuel system, it is highly
recommended to use a fuel additive/stabilizer formulated for ethanol fuels. Follow the stabilizer manufacturer's instructions. Run
the engine for at least 5 minutes after adding stabilizer .
1 . Let the engine run until it is out of gasoline . Remove the carburetor screw from bowl and drain fuel . Tilt unit slightly to
remove all fuel . Replace screw .
2 . Change the oil by following instructions under "How to Change the Oil ."
3 . Remove the spark plug from the cylinder . Pour one ounce of oil into the cylinder . Slowly pull the recoil-start handle so
that the oil will protect the cylinder . Install a new spark plug in the cylinder . Pull starter handle slowly a few times to
distribute oil . Pull recoil slowly until resistance is felt . This will close the cylinder valves .
WARNING
Do not attach spark plug wire to spark plug when storing unit .
4 . Clean tiller . Remove all dirt, leaves, debris, grease, etc . from the tiller - including cylinder cooling fans, recoil starter
cover holes, under fuel tank, and under muffler.
5 . Check the tiller for worn or damaged parts . Have damaged parts replaced if necessary .
6 . Tighten any loose hardware .
7 . Apply lubrication as directed in Maintenance section .
8 . Put the unit in a building that has good ventilation .
9 . Cover the tiller with a breathing material .

Technical Service

You may have further questions about assembling, operating, or maintaining this TILLER . If so, you can contact our
Technical Service Department at 1-800-737-2112 (English only) .
You may also write to:
METL Corporate Office - CORRESPONDENCE ONLY
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Your Phone Number
Questions? Call Toll Free at 1-800-737-2112
(Continued)
If you need assistance or have any questions,
CALL TOLL FREE: 1-800-737-2112.
• Model Number of Product
• Date of Purchase (include copy of receipt for written requests)
• Date Code on Product
Copyright © 2019 MAT Engine Technologies, LLC
18