TP-Link PW-DN427 User Manual page 19

supports.
Note:
To build a successful connection by WPS, you should also do the corresponding configuration of
the Access Point for WPS or WPS function meanwhile.
I. PBC Method
If your Access Point is equipped with a push-button for Wi-Fi Protected Setup, you can connect
the adapter to the Access Point by Push WPS Button method.
Step 1 Press the WPS button on your Access Point device.
Step 2 Click the WPS button (marked by the red circle) on the screen as Figure 3-9.
Or: Press and hold the WPS button on the adapter for 2 or 3 seconds.
II. PIN Method
If your Access Point supports Wi-Fi Protected Setup and the PIN method, you can add the
adapter to the network by the following two ways:
1) Enter a PIN from my Access Point
Choose the Config Mode as Registrar and enter the PIN of AP into the field under the Pin Code
as Figure 3-10 shown. And then click PIN button to start the wireless connection without doing
any configuration for AP.
PW-DN427
Figure 3-9 WPS- WPS BUTTON mode
- 15 -
Wireless Lite-N USB Adapter User Guide