Graco HVLP TurboForce II 7.0 Quick Operator's Manual

WARNING
SETUP
STANDARD
Turn power switch to OFF position.
Fill FlexLiner™ with material to
'MAX FILL' line. Clean threads and
sealing surfaces if needed.
CHOOSE THE RIGHT NOZZLE
FLUID SET #2
PRODUCT
17P485
Dye
Ink
Non-Wiping Stain
Automotive Finish
Lacquer
Stain
Enamel
Epoxy
Urethane
Varnish
Primer
Industrial Finishes
Latex
Multi-Spec
Butyrate
Nitrate Dope
Solvent-Based Wall Paint
OPERATION
ROTATE air cap to
HVLP EDGE™ II PLUS.
desired spray pattern.
www.graco.com
HVLP TurboForce
7.0 / 9.0 / 9.5
Quick Operator's Guide
This procedure is for water-based paints and flushing agents. For solvent-based paints and flushing agents (i.e. mineral spirits), you must first
read the section on Fire and Explosion Hazards in the Operating Instructions. Please note this Quick Guide is at no means replacing the official
Graco manual. Graco can at no means be liable for any consequences of not following the safety regulations as stipulated in the official manual.
* Please check the Graco operations manual supplied with the unit for more details.
PROCONTRACTOR
Disconnect spray gun
Screw cover and ring onto cup. Connect FlexLiner™ System
Tighten ring securely.
FLUID SET #3
17P486
PROCONTRACTOR ONLY
pattern by rotating air
cap retaining ring.
from air hose.
to gun. Connect air hose to gun.
FLUID SET #4 FLUID SET #5
17P487 17P488
AutoStart setting automatically turns off
when not actively spraying. Sprayer will start
upon re-triggering of HVLP Edge II Plus gun.
Turn switch to ON position if AutoStart is not
desired.
II
™
Unscrew ring
from cup.
Remove lid
Disconnect
and ring from
gun from
cup. Verify
FlexLiner™
FlexLiner™ is
System.
in cup.
Verify trigger slide is
in SPRAY position.
Sprayer is now ready to use.
FLUID SET #6 FLUID SET #7
17P489 17P490
A
Verify trigger slide is in SPRAY
position (A), not NEEDLE REMOVAL
position (B).
B