Samsung RF22 Series User Manual page 20

Reassembling the freezer door
1. Pull out the rails to the full length on each sidle
of the cabinet evenly.
2. Hang the freezer door front onto open slot on
the sides.
3. With the 10 mm wrench, reattach 4 bolts to
connect the rail with the door.
4. With the drawer pulled out fully, insert the
drawer box into the rail system.
20_ setting up
DA68-02787M-00.indb 20
Slot
ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, it will not be
possible to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into a notch
on the left control lever, and turn it count
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)
flat-blade Control Lever
screwdriver(-)
Both control levers must be touching the
floor to avoid possible personal injury or
CAUTION
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
2019. 1. 31. 9:29