PROEL FLASH8XD User Manual page 11

5. MIC GAIN control
The MIC level control adjusts the sensitivity of the mic input. The minimum gain is with the knob all way down, ramping
up to maximum gain when rotated fully clockwise.
NOTE: when several speakers are linked using the MIX OUT connector, if a microphone is connected to the first one its
MIC LEVEL control adjusts the mic level for all the linked speakers. In this case, make sure the the LINE LEVEL control of
all the linked speakers is fully open.
6. SIGN/LIMIT indicator
2-color LED.
GREEN: indicates the presence of signal at the amplifier input.
RED: indicates that the amplifier's is reaching its maximum output power, so the DSP LIMITER is working. When this LED
flashes RED continuously reduce the input signal level.
7. FRONT LED OFF button
This button disables or enables the front LED, which indicates when the system is ON.
8. DSP MODE button
Use this button to select one five EQ PRESETS (MUSIC, LIVE, DJ, MONITOR, SPEECH) available for adapting the
FLASH12XD to different applications.
9. PRESET indicator
These GREEN LEDs show the current EQ preset loaded in the DSP.
MUSIC: to be used for recorded music playback. This is the default preset.
LIVE: to be used for reproducing at best vocals and instruments in live applications.
DJ: specifically designed for recorded dance and electronic music playback.
MON: to be used when the loudspeaker is used as a floor monitor for musicians and DJs.
SPEECH: to be used for spoken word applications, in particular when a dynamic microphone is connected directly to
the system.
10. POWER switch
Speaker is "ON" when the switch is in the "I" position.
NOTE: When you shut down your equipment, turn off the speaker first. When powering up, turn on the speaker last.
12. FUSE holder
Here is placed the mains protection fuse.
WARNING: REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.
IF, AFTER THE REPLACEMENT, THE FUSE BLOWS AGAIN, DO NOT TRY AGAIN TO REPLACE IT BUT CONTACT THE
NEAREST PROEL SERVICE CENTER.
12. AC~ socket
Here's where you plug in your speaker's mains supply cord. You should always use the mains cord supplied with the
speaker. Be sure your speaker is turned off before you plug the mains supply cord into an electrical outlet.
11