Samsung PM55H User Manual page 63

Chapter 5. Menu
Automatic Network Settings (Wired)
Connect to the network using a LAN cable.
Make sure a LAN cable is connected first.
How to set up automatically
1 Press the button on the remote control.
MENU
2 Select Network - Open Network Settings.
3 Select Wired.
‒ The network test screen appears and then the verification process starts.
4 When the connection has been verified, select OK.
• If the connection process fails, check the LAN port connection.
• If the automatic process cannot find the network connection values or if you want to
set the connection manually, go to the next section, network setup.
Manual Network Settings (Wired)
Offices may use static IP addresses.
If this is the case, ask the network administrator for the IP address, subnet mask,
gateway and DNS server address. Enter these values manually.
Getting the Network Connection Values
To view the Network connection values on most Windows computers, follow these
steps.
1 Right click the Network icon on the bottom right of the screen.
2 In the pop-up menu that appears, click Status.
3 On the dialog that appears, click the
4 On the Support Tab, click the Details
displayed.
How to set up manually
1 Press the button on the remote control.
MENU
2 Select Network - Open Network Settings.
3 Select Wired.
‒ The network test screen appears and then the verification process starts.
4 Select Stop. The verification process stops.
Support tab.
button. The Network connection values are
5 Select IP Settings. The IP Settings screen appears.
6 Select IP Setting and set it to Enter
‒ Setting IP Setting to Enter Manually
Manually.
7 Enter the network connection values.
‒ I P Address, Subnet Mask, Gateway,
8 When done, select OK at the bottom of the page, and then press
test screen appears and the verification process starts.
9 When the connection has been verified, select OK.
Manually.
automatically changes DNS Setting to
DNS Server.
. The network
63
Enter