Advertisement
Quick Links
General Guide for Installation
- Install the device as far as possible from metal parts and wiring
Altox
harnesses.
- For better receiving of GPS-GLONASS signals direct the upper part of the
device casing to the windshield minding metal obstacles.
- Recommendation: connect device supply directly to the OBD-II connector
wires where pin 16 is +12В, pin 4 is GND (common).
Please indicate the place of ALTOX module's location in the vehicle for
possible maintenance:
Authorized Service:
Installation Date:
O p e r a t i o n a l M a n u a l
ALTOX TRACKER-4
Advertisement
Related Manuals for Altox TRACKER-4
Summary of Contents for Altox TRACKER-4
- Page 1 - Recommendation: connect device supply directly to the OBD-II connector wires where pin 16 is +12В, pin 4 is GND (common). Please indicate the place of ALTOX module's location in the vehicle for possible maintenance: Authorized Service:...
- Page 2 - number of satellites and HDOP parameter your vehicle. Speed: 0km/h - current speed You need a SIM card for your ALTOX device. It is recommended to use Volt: 12.8V - car-system voltage special plans for M2M equipment. I/O: 0,0,0 - IN, OUT1 and OUT2 status http://google.com/maps - link to the current location in Google Maps...
- Page 3 TRACKING1 /0 Switch on auxiliary output OUT1 ACTIVATE / OUTPUT_ON Note: after the setting of the APN point, ALTOX tracker will switch into Switch off auxiliary output OUT1 DEACTIVATE / OUTPUT_OFF GPRS mode. To capture movement history send instruction TRACKING1. In...
- Page 4 Settings 6. CALL0 setting switches the module into the mode of dropping incoming calls which allows saving money (in this case output OUT1 You can enter several settings simultaneously, dividing them by commas. reverses its state).. If the password is set (PASS:XXXX), then before entering any instruction, 7.
Need help?
Do you have a question about the TRACKER-4 and is the answer not in the manual?
Questions and answers