Table of Contents
Advertisement
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
12
. Snug 4 wing nuts on the
mounting stud, but do not
tighten.
15
. Check for correct clearance
between wick holder and draft
tube. It should be the same all
around.
18
. Fasten the Cabinet & Grill
assembly to the heater with 3
screws. Replace the Wick-
Adjuster Knob and ignition Knob
to the heater.
13
. Raise the wick to the full "up"
position, and evenly tighten
wing nuts in several steps.
16
. Check the function of safety
shut-off mechanism by
pushing the extinguish button
to upset the pendulum.
11
14
. Check height of wick.
It should be 5/16" above collar
5/16"
17
. Tilt the Cabinet & Grill assembly
slightly using both hand and
replace on heater from front to
rear.
Advertisement
Table of Contents
