Advertisement
4
Connecting each Cable and the Unit and Installing
Connect Gauge Cable and OBD Cable to the Unit
●Gauge Cable
Connect to the Unit.
※The 3-pin connectors can
be connected to any of the
three positions
Installing the Unit
Fasten the unit into positions not usually affected by water.
Fastening to Flat Space
Unit
Double-sided
tape(Square)
Clean to
remove
oil and dust.
Basic Operation
1
Key Switch ON
(Engine start)
START
ENGINE
STOP
START
Troubleshooting
Trouble
Meters do not work.
※Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
※We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar designs,
regulating characteristics, circuitry and circuitry layout.
※We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User' s Manual.
4
●Fuse Power Cable
When Fastenings to
a Cable or Pipe
Zip tie
(Large)
Through
holes
Thick cable
or pipe
2
3
Opening Demo
(Start-up all together)
Possible Causes
Poor connection of Gauge Cable ,
OBD Connector and Fuse Power Cable .
Poor connection or wrong wiring of Red
cable if wired directly to the power supply.
The unit has been installed into an incom-
patible car model.
PIVOT CORPORATION
Connect to
1-pin connector
of OBD Cable.
Notes about using the OBD Connector
If you unable to get a grip
on the distended portions.
W i t h s o m e c ar m o d e l s i t
m ay b e d i f f i c u l t t o g e t a
good grip on the connector.
How to use the Cut Connectors
1
10
2
mm
Peel off of the vinyl
Peel off of the vinyl
cover at the end of
cover at connection.
the product' s wire.
5
4
Close tightly with cut
Insulate with vinyl
connector.
tape.
4
Real-time display
Key Switch OFF
(Engine stop)
START
ENGINE
STOP
Please reconfirm whether wiring and connec-
tions of Gauge Cable , OBD Connector and
Fuse Power Cable are correct or not.
Please reconfirm whether wiring and connec-
tions of Red cable is correct or not.
Please check the "Fitting List" .
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 JAPAN
●OBD Cable
Connect to the Unit.
Do not pull on the wires
Make sure to grip the
distended por tions
when trying to remove the
when pulling it out or
connector; the wires may
inserting it.
become disconnected.
10
mm
3
Wrap around both wire
coils.
When crimping, please
use crimpers or use pliers
to bend and then solder
together.
5
Meter OFF
STOP
Possible Solutions
In such case, pull
out the connector
by pulling on the
end of the zip tie.
Advertisement
