Security Mode; Ka Max Mode - Whistler PRO3700 Manual

OPERATION

Security Mode

When the unit is powered off by the Vehicle Battery Saver
Mode or by pressing the power button, the Security LED will
begin to flash if the security LED option is turned on. This
simulates a vehicle alarm system.
X/K and Ka Filter Modes
There are times when a radar detector in another vehicle, can
emit a frequency which can cause your detector to falsely alert.
These Filter Modes allow you to select the level needed for your
area to minimize the occurrences of these false alerts. X/K and
Ka Filter Mode factory default settings should provide adequate
filtering for most conditions. If you experience excessive alerts
due to radar detectors in other vehicles, increase the Filter level
for the band received. See Option Selection Mode to change the
filter settings.
NOTE: Speed selectable Filter is available with the optional GPS
module.

Ka Max Mode

Ka Max Mode provides enhanced Ka sensitivity - increased
detection. This mode can be selected with or without RSID. See
Option Select Mode for changing Ka options.
VG-2 Detection Mode
See Option Select Mode to turn this feature on/off. When a VG-2
signal is detected, the VG-2 alert is sounded and the display
flashes "VG-2". After 3 seconds the audio is canceled and the
display no longer flashes. This cycle is repeated if the VG-2 signal
is detected again .
During the period a VG-2 signal is detected, a radar signal
cannot be detected.
However, because the VG-2 alert has confirmed that a patrol
car is nearby, you are already aware of the potential for speed
monitoring and can adjust your speed accordingly. Laser
detection is not affected while a VG-2 signal is detected.
16