Mercedes-Benz E-Class Wagon Operator's Manual page 27

Hide thumbs Also See for E-Class Wagon:
Table of Contents

Advertisement

If you modify component parts of these high-
voltage components or touch damaged com-
ponent parts, you may be electrocuted.
High voltage components may be damaged in
an accident, although the damage may not be
visible.
Never perform modi cations to compo-
#
nent parts of high-voltage components.
Never touch damaged component parts
#
of high-voltage components.
Never touch component parts of high-
#
voltage components a er an accident.
Vehicles with a 48 V on-board electrical system
contain high voltage components. These compo-
nents are marked with a high voltage label:
All work on high voltage components must be car-
ried out at a quali ed specialist workshop.
Declar
Declaration of conf
ation of confor ormity f
mity for v
or vehicle inst
ehicle installed
r r adio com
adio components
ponents
USA: "Radio based devices of this vehicle comply
with Part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions: 1) These devi-
ces may not cause harmful interference, and 2)
These devices must accept any interference
received, including interference that may cause
undesired operation.Changes or modi cations not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment."
Canada: "This vehicle contains licence-exempt
transmitter(s)/receiver(s) that comply with Inno-
vation, Science and Economic Development Can-
ada's licence-exempt RSS(s). Operation is subject
to the following two conditions: (1) These devices
may not cause interference. (2) These devices
must accept any interference, including interfer-
ence that may cause undesired operation of the
devices." "Les émetteurs/récepteurs dans cette
véhicule sont conforme aux CNR d'Innovation,
alled
Sciences et Développement économique Canada
applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux con-
ditions suivantes : 1) Ces appareils ne doivent pas
produire de brouillage; 2) Ces appareils doivent
accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en com-
promettre le fonctionnement."
General notes
25 25

Advertisement

Table of Contents
loading

Table of Contents