DeWalt DW516K Manual page 21

intervals and, if damaged, have them repaired by
an D WALT authorized repair agent. Inspect the
E
extension cords periodically and replace them
if damaged. Keep all controls dry, clean and free
from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment and
seizure of moving parts, breakage of parts and any
other conditions that may affect its operation. Have
damaged guards or other defective parts repaired
or replaced as instructed. Do not use the tool if the
switch is defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Package contents
The package contains:
1 Heavy Duty Rotary Drill/Dry diamond drill
1 Side handle
1 Depth gauge
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your professional D WALT DW516K D-handle
E
Rotary Drill has been designed for heavy duty
drilling, mixing and dry diamond core drilling,
with core drill bits up to 90 mm.
1 Variable speed switch
2 Two gear selector
3 Side handle
4 Depth adjustment rod
5 Keyless chuck (option)
6 Keyed chuck
7 Sleeve
8 Chuck key
15
Torque limiting clutch
Your drill is equipped with a torque limiting clutch
that reduces the maximum torque reaction
transmitted to the operator in case of jamming of
a drill bit. This feature also prevents the gearing and
electric motor from stalling. The torque limiting
clutch has been factory-set and cannot be adjusted.
Electronic speed control
The electronic speed control enables optimal tool
control for accurate drilling.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore
no earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous
if engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
E N G L I S H
en - 3