Download Print this page
Chamberlain 881LM Quick Manual
Chamberlain 881LM Quick Manual

Chamberlain 881LM Quick Manual

Premium motion-detecting control panel

Advertisement

Quick Links

For use with Security✚ 2.0
Garage Door Openers. All Security✚ 2.0
TM
a yellow Learn button and two yellow antennas. The features are adjustable and may be turned off
or on as desired. Refer to the Feature Settings section.
Feature Overview
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned
on they will stay on until the LIGHT button is pressed again, or until the garage door opener is
activated. Once the garage door opener is activated the lights will turn off after the specified period
of time (the factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the
door is in motion.
MOTION SENSOR
The motion sensor will automatically turn on the garage door opener lights when motion is
detected. The lights will come on for the set period of time, then shut off. The factory setting is on
and set at 4-1/2 minutes.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for
added peace of mind when the home is empty (i.e. vacation).
MAINTENANCE ALERT SYSTEM (MAS)
This feature assists the homeowner in ensuring the garage door opener system stays in good
working condition. The MAS feature MUST be activated at time of installation. The factory setting
is off. The service LED will come on after 4500 garage door opener cycles. This indicates the
garage door opener may need maintenance; contact your installation dealer. If the MAS feature is
activated, the command LED (yellow) and the service LED (red) will alternate flashing back and
forth.
TIMER-TO-CLOSE (TTC) FOR MODEL 881LM ONLY
DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors.
The TTC can be set to automatically close your garage door after a specified period of time (1, 5,
or 10 minute intervals). The garage door opener will beep and the lights will fl ash before closing
the door. If the door encounters an obstruction while closing, the garage door opener will make a
second attempt to close the door. If the obstruction has not been cleared after the second attempt,
the garage door opener will reverse open, stop and WILL NOT close until the obstruction has been
cleared. TTC WILL NOT work if the garage door opener is operating by battery power or if the
safety reversing sensors are misaligned. This feature is NOT intended to be the primary method of
closing the door. A keyless entry should be installed in the event of an accidental lock out when
using this feature.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifi cations of this receiver and/or transmitter are
prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards for Home or offi ce use. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
For more information, please visit www.devancocanada.com or call toll free at 855-931-3334
Garage Door Openers have
TM
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is NOT connected BEFORE installing door control.
• Connect ONLY to 12 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
• Install door control within sight of garage door, out of reach of children at a minimum
height of 5 feet (1.5 m), and away from ALL moving parts of door.
• NEVER permit children to operate or play with door control push buttons or remote control
transmitters.
• Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no
obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross
path of closing garage door.
1
PREMIUM MOTION-DETECTING CONTROL PANEL
Yellow
LEARN Button
Safety Reversing
Premium Motion-Detecting
Sensors
Control Panel
Models 881LM and 886LM

Advertisement

loading

Summary of Contents for Chamberlain 881LM

  • Page 1 LED (yellow) and the service LED (red) will alternate flashing back and forth. TIMER-TO-CLOSE (TTC) FOR MODEL 881LM ONLY DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors.
  • Page 2: Installation

    Installation HARDWARE Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small children cannot reach, and away from the moving parts of the door. For gang box installations it is DRYWALL GANG BOX not necessary to drill holes or install the drywall anchors.
  • Page 3: Operation

    Operation PUSH BAR TIMER-TO-CLOSE (TTC) 881LM ONLY Press the push bar to open/close the door. DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional GARAGE DOOR OPENER LIGHTS doors. Press the LIGHT button to turn the garage door...
  • Page 4: Feature Settings

    Warranty ONE YEAR LIMITED WARRANTY FOR SERVICE DIAL OUR TOLL FREE NUMBER: The Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that is free For more information, 1-800-528-9131 from defect in materials and/or workmanship for a period of 1 year from the date of purchase.
  • Page 5 HOW TO ORDER REPAIR PARTS DEVANCO CANADA 19192 HAY ROAD, UNIT Q SUMMERSTOWN, ON K0C 2E0 TOLL FREE: 855-931-3334 www.devancocanada.com WHEN ORDERING REPAIR PARTS PLEASE SUPPLY THE FOLLOWING INFORMATION: 3 PART NUMBER 3 DESCRIPTION 3 MODEL NUMBER...

This manual is also suitable for:

886lm