Finishing The Installation - Cabletron Systems EMC38-12 User Manual

CHAPTER 3: CONNECTING TO THE NETWORK
5. Attach the fiber labeled 2 to the receive port.
6. Check that the FOLNK LED on the ECM38-12 is on. If the LED is
not on, perform the following steps until it is:
a. Check that the power is turned on for the device at the other end of
the link.
b. Verify proper "receive to transmit" connection of fiber strands
between the applicable port on the module and the fiber optic
device at the other end of the fiber optic link segment.
c. Verify that the fiber connection meets the dB loss specifications
outlined in Appendix A.
If a link still has not been established, contact Cabletron Systems
Technical Support.

3.3 FINISHING THE INSTALLATION

The EMC38-12 is now ready for operation. Before placing the network
into service, test the installation thoroughly, making sure that you can
address all stations and that the EMC38-12 and all stations are indicating
normal operation. Ensure that the networking software is configured
properly to match the installed network. If you encounter errors or
abnormal operation, contact Cabletron Systems Technical Support.
Page 3-4 EMC38-12 USER'S GUIDE