Table of Contents
Advertisement
Quick Links
Installation & User
All spares available from
Copyright Notice: All rights reserved. No parts of this manual may be reproduced in any form without
express written permission of Maidaid-Halcyon(A trading name of Buttress Group Ltd)
D511
Guide
The Engine Shed
Top Station Road
Brackley
NN13 7UG
Tel: 0845 1308060
Fax: 01280 845345
Web: www.caterparts.com
Advertisement
Table of Contents
Related Manuals for Maidaid Halcyon D511
Summary of Contents for Maidaid Halcyon D511
- Page 1 D511 Installation & User Guide All spares available from The Engine Shed Top Station Road Brackley NN13 7UG Tel: 0845 1308060 Fax: 01280 845345 Web: www.caterparts.com Copyright Notice: All rights reserved. No parts of this manual may be reproduced in any form without...
-
Page 2: Table Of Contents
INSTRUCTION MANUAL FOR DISHWASHERS CONTENTS CHAP 1 PREFACE ........................2 CHAP 2 INSTALLATION ......................2 ........................2 NPACKING ........................3 OSITIONING ....................3 LECTRICAL CONNECTION ....................4 ATER CIRCUIT HOOKUP ..................4 ONNECTION TO THE DRAIN LINE ....................4 INSE AID AND DETERGENT CHAP 3 RISKS AND IMPORTANT WARNINGS .............. -
Page 3: Chap 1 Preface
INSTRUCTION MANUAL FOR DISHWASHERS Chap 1 PREFACE This manual contains important safety warnings relating to installation, use and maintenance. Failure to observe the instructions in the enclosed documentation may compromise the safety of the appliance and immediately voids the warranty. Warnings: Keep all documentation in the vicinity of the appliance;... -
Page 4: Positioning
INSTRUCTION MANUAL FOR DISHWASHERS 2.2 Positioning • Check that there are no objects or materials in the installation area which may be damaged by the steam emitted by the appliance during operation, or if there are, make sure they are properly protected. •... -
Page 5: Water Circuit Hookup
INSTRUCTION MANUAL FOR DISHWASHERS 2.4 Water circuit hookup The appliance must be connected to its water supply with a flexible hose. A shut off valve (cock) must be installed between the water supply line and the appliance's solenoid valve. The cock must be close to the appliance. •... -
Page 6: Chap 3 Risks And Important Warnings
INSTRUCTION MANUAL FOR DISHWASHERS Chap 3 RISKS AND IMPORTANT WARNINGS • This appliance is intended solely for the use for which has been designed. Any other use is improper and hazardous. • The specialised technician responsible for installing the appliance must instruct the user on its operation and any attendant safety measures, including practical demonstrations. -
Page 7: Chap 4 Using The Machine
INSTRUCTION MANUAL FOR DISHWASHERS Chap 4 USING THE MACHINE 4.1 Key and symbols Referring to Fig.1: ON/OFF BUTTON 4 INFORMATION DISPLAY PROGRAMME SELECTION BUTTON 5 STATUS BAR (LED) START BUTTON 6 CHECK BAR (LED) Switching the dishwasher on Referring to Fig.2: •... -
Page 8: Continuous Washing (*Optional)
INSTRUCTION MANUAL FOR DISHWASHERS Continuous washing (*optional) • This is an extended cycle; the time varies according to the model. • The cycle duration may be varied as required by pressing START (3) during the wash cycle, to interrupt the wash and start the rinse phase. 4.6 Special programmes (*optional) To increase its operating flexibility, the machine has some special programmes. -
Page 9: Automatic Cycle Start-Up
INSTRUCTION MANUAL FOR DISHWASHERS 4.7 Automatic cycle start-up This function is used to make the chosen cycle start automatically when the door is closed. To enable, proceed as follows (Fig.6): • With the appliance on and the door open, press and hold (for at least five seconds) START (3) until AS appears on the display. -
Page 10: Displaying Information
INSTRUCTION MANUAL FOR DISHWASHERS • Rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of corrosion. • The ‘SALt’ warning will disappear after a few minutes. The warning rEG on the display indicates that the machine is running a resin regeneration cycle, needed to ensure the correct operation of the water softener;... -
Page 11: Chap 5 Maintenance
INSTRUCTION MANUAL FOR DISHWASHERS Chap 5 MAINTENANCE 5.1 General rules Before doing any maintenance, completely drain out all water, shut off the power supply and close the water supply cock. Do not use water under pressure - it can damage the electrical equipment. Only wash the body panelling when it is cold, using only product specifically designed for steel. -
Page 12: Chap 6 Self Diagnostics
INSTRUCTION MANUAL FOR DISHWASHERS Chap 6 SELF DIAGNOSTICS The machine is equipped with a self-diagnosis system that registers and warns of a number of malfunctions. Fault Description and possible remedies No rinsing. The rinsing cycle was not completed correctly. Make sure that the rinsing nozzles are clean. -
Page 13: Chap 7 Settings
INSTRUCTION MANUAL FOR DISHWASHERS Chap 7 SETTINGS The following settings should only be configured by a qualified technician. The parameters listed below can be set during installation of afterwards, accessing the settings menu as follows: • Machine in standby with door open. •... -
Page 14: Hardness Settings For The Incorporated Water Softener
INSTRUCTION MANUAL FOR DISHWASHERS 7.1 Hardness settings for the incorporated water softener Set the hardness level of the water supply dH in the settings menu following the instructions given in the following table: Measured hardness °fr n° 0 ÷ 20 0 ÷... - Page 15 INSTRUCTION MANUAL FOR DISHWASHERS Page 14 of 14...
Need help?
Do you have a question about the D511 and is the answer not in the manual?
Questions and answers