Advertisement
Pairing / Binding The Transmitter
Having followed steps 1 to 10, in the unlikely event that your car does not operate please
follow the 5 stage pairing process detailed here.
1
Remove the body and locate the
ET3 Krypton receiver.
2
Place your Conquest and ET3
transmitter in close proximity but
not less than 12" (300mm) apart.
3
Press and hold the PAIR / BIND
button on the receiver then switch
the receiver on. The receiver's
LED will flash to indicate that it is
in PAIR / BIND mode.
4
Press and hold the PAIR / BIND
button on the transmitter then
switch the transmitter on. Release
the PAIR / BIND button only when
the transmitter's LED begins
flashing.
5
When the LED on the receiver
lights solid red your ET3
transmitter and Conquest will
be bound. You will now have full
control of throttle and steering.
Return to Step 11 of this guide to
complete the set-up of your car.
Full manual available to download from: www.Helion-RC.com
300mm
Advertisement
