Linea DOMO DO7279S Instruction Booklet page 34

DO7279S
ASSEMBLY
Always remove the plug from the socket before adding or removing accessories.
1. Flexible hose: Attach the flexible hose to the air intake opening at the front of the
vacuum cleaner. Push the hose until it clicks into position.
2. Metal tubes: Attach the metal tubes to the handle. Attach the floor brush to the
metal tubes.
3. Accessories: Crevice/dust brush and small floor brush.
INSTRUCTIONS FOR USE
Before using the appliance unwind the power cord. Put the plug into the socket. A
yellow marking on the cord indicates the ideal length for unwinding the cord. On
the power cord is also a red marking, never unwind the power cord further than this
marking.
1. Press the on/off button to turn on the unit.
2. To wind the cord, remove the plug from the socket en hold it while pressing the
rewind button with the other hand. You need to hold the plug while rewinding to
prevent damage during rewinding.
3. On the handle that is attached to the tubes, there is a small slide button for extra
suction control.
CLEANING DUST CONTAINER AND FILTERS
Before cleaning your vacuum cleaner or accessories, always turn off the appliance and
remove the plug from the socket.
Dust container
1. Take hold of the handle, press the silver coloured button on
top of the dust container and gently pull the dust container
upwards. The dust container slides out of the appliance.
2. On the side of the dust container there is a knob.
3. Keep the container above the dust bin. Press the button on
the side of the dust container. The bottom will open and the
dust will fall out.
34