Table of Contents
Advertisement
Chapter 2
Switching on
Follow the instructions on this page on how to switch on your TV set and the remote
control before going on to following pages describing how to use the channel set-up
procedure.
1. Insert two batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine, fire or the like,
throw them in a fire, recharge them or try to open them, as this could cause
them to leak or explode.
- Remove the batteries from the remote control if you are not using it for a long
period of time.
2. Connect an outside aerial to the ANTENNA IN socket at the back of the TV set.
3. Connect the power cable firstly to the television, then to a mains socket.
4. Now the TV set is in standby mode with power indicator.
Press the
button on the remote control or on the TV set to turn on the TV.
Switching off
To put the TV set into standby mode, press the
the TV set remains powered up, but with low energy consumption.
To switch off the TV set, long press
then unplug the power plug from the mains outlet.
button on the remote control,
button on remote control and select
12
General Operation
"
power off ",
Advertisement
Table of Contents
