VENTRA RVM-2XC233 Quick Start Manual

Parts included:
• EX4-XC2 Outdoor Color Camera w/ IR x 2
• VLCD-7 7" LCD Screen x 1
• EX4-CBL33 33ft 4 pin DIN cable x 2
• RVC-PIG DIN to RCA / Power Cable x 2
Warning:
Install equipment only when vehicle is safely parked, leveled and power Off
View and access the monitor only when safe to do so
Review surrounding before operating / moving vehicle
Observe all electrical safety guideline and polarity to avoid injury
Please consult with Vehicle Manufacturer for warranty and settings prior to installation
Ventra is not responsible for any warranty pertaining to the vehicle
InstallationGuide
1. Determine the location and mounting position of the camera prior to installation
2. Test the viewing angle by powering both the camera and monitor before permanently securing the camera
3. Once location is determined, securely affix mounting bracket of the camera to the vehicle
4. Connect the EX4-XC camera to EX4-CBL 4 pin DIN cable. Ensure the cable is securely connected. (Refer to
installation diagram). EX4-CBL cable is not waterproof and should NOT be exposed to direct sunlight, rain or element. Cable should be
placed in conduit or outdoor rated sleeve
5. Connect the EX4-CBL cable to RVC-PIG DIN to RCA / Power cable
1. RVC-PIG:
Red
- 2 power pigtail wire (
- DC power plug to EX4-XC camera
- RCA connection to monitor via RCA cable
7. Secure RCA cable connection by applying heat shrink tube or electrical tape. Constant vehicle vibration may loosen connection
8. Connect the RCA cable into VLCD-7 video input
Ventra Technology Inc.
Black
= 12V Positive, = Ground) to a power source (i.e. tail light, reverse light or vehicle fuse)
Covina, CA.USA www.ventrainc.com
RVM -2XC233 Rear View Camera Kit
Specification
:
Camera
Chipset
Camera Lens
Resolution
Camera Angle
Camera Rating
IR LED
Illumination
S/N ration
Electronic Shutter
Auto Gain Control
Back Light Compensation
White Balance
TV System
Camera Power
Humidity
Temperature Range – Operating
Monitor
LCD Screen Size
Resolution
Channels
Brightness / Contrast
OSD Control
Viewing Mode
Monitor Power
Cable
Environment
Pin
info@ventrainc.com
1/3" CMOS
2.8mm
600 TVL
120 degrees (D) / 90 degrees (H)
IP66 Outdoor Rated
12 LED
0 Lux – IR on
>54db
1/60 ~ 100,000
Auto
Auto
Auto
NTSC
DC 12V ~ 24V 160mA
<90%
-4F ~ 150F ( -20C ~ +65C)
7" TFT LCD
800 x 480
2 – RCA Video Input
500cd/m2 / 500:1
Contrast, Sharpness, Brightness, NTSC
Normal, Mirror, Flip
DC 12V ~ 24V 150mA
Indoor
4 Pins (Video, Audio and Power)
Tel: 888 4183833
V. 07 18