Page 2
The power supply provided with this kit is a 40 watt unit with linear +5VDC, +12VDC and - 12VDC outputs, used on many Milnor machines. Although it replaces a power supply of the same general specifications, you will probably need to make certain modifications to accommodate the new power supply.
Page 3
Replacing Power Supply 08PSS3401T (for Retrofit Kits 08PSS3401N and 08PSS3401X) Figure 1: Mounting the Power Supply Board Arrangement of Mounting Hardware Legend Power supply board Mounting bracket, if used, or Processor box Nylon bolt, nuts and spacer—three places Metal bolt, nuts and lock washers;...
Page 4
This is necessary for the power supply to be able to maintain the specified output. Machines that use this power supply have processor boards with Milnor part numbers beginning with “08BSP...”, “08BN...” or “08BH...” You will need to read the part number printed on your processor board (usually on a sticker affixed to the board).
Consult the original schematic manual for wire colors on an older machine or contact the Milnor factory. CAUTION 3 : Component Damage Hazard—Wire V3, which supplies -12VDC, is not used on certain machines (e.g., machine models ending in C4A, M4A, or M4E, as well as...
Page 6
—Once the power supply has been swapped out Kit 08PSS3401X (for Newer Machines) 3.1. and the electrical connectors plugged into the new power supply, all that remains is to install the , and if applicable, the resistor. PELLERIN MILNOR CORPORATION...
Page 7
Replacing Power Supply 08PSS3401T (for Retrofit Kits 08PSS3401N and 08PSS3401X) 1. Install the MOV across the power supply's incoming power conductors, as shown in Figure 3. Splice the leads of the MOV as close as possible to the connector on the power supply side.
Page 8
Figure 4: Milnor Tag B2T2003041 Showing Power Supply Adjustment Instructions — End of BICUUR01 — PELLERIN MILNOR CORPORATION...