Panasonic WX-CS560 Operating Instructions Manual page 7

Do not replace parts in the state of the
product mounted.
There is a risk of parts falling, resulting in acci-
dents.
Do not install the product with deformed
or damaged mounting fixtures.
There is a risk of the product falling and caus-
ing accidents.
If a crack is observed on the surface of
the product, stop using and remove the
product.
This could cause the product to fall. Be sure to
consult your dealer.
Disassemble any product that is no longer
used or is inoperable; do not leave it unat-
tended.
As parts corrode, there is a risk of the product
falling. Be sure to consult your dealer.
Make sure to inspect after an earthquake.
This could damage the mounting fixtures of the
product, causing it to fall.
Be sure to consult your dealer.
Do not use excessive force.
If the mounting fixtures are damaged, this could
cause the product to fall and lead to accidents.
Ask a professional service company for
disposal.
If the product is burned at your site, the
included chemicals may hurt your eyes, or
cause a fire or a burn injury.
Always turn off the center module before
disconnecting or connecting wires.
Otherwise, electric shock may result, and click-
ing noise may damage the unit.
Do not expose to vibration or strong
impact.
Otherwise fire, electric shock or damage may
result.
Be sure to use the product in combination
with the products for the Panasonic
Wireless Communication System.
Otherwise fire or electric shock may result.
Do not put or install near the equipment or
substance which are affected by magnetic
field.
Bringing magnetic recording media such as
tape, floppy disks or MDs near the product will
result in erasure of recorded data.
In addition, installation of the product near the
equipment or substance which are affected by
magnetic field may lead to damage or malfunc-
tions.
Do not install the product in places of
1.5 m {5 feet} or higher.
The product is not intended for the installation
in high places. Safety measures such as safety
wires are not provided.
[Precautions for use]
Product care
Turn off the center module connected with this
product before cleaning it. Otherwise injuries
may result. Wipe with a dry soft cloth. Do not
clean with volatile liquids such as benzene and
thinner. When using a chemical cloth for clean-
ing, observe the cautions provided with the
product.
Operating temperature
–20 °C to +50 °C {–4 °F to 122 °F}
Using the product at temperatures outside this
range will negatively affect internal parts and
lead to damage or malfunctions.
7